| Posted By |
Discussion Topic:
1932 Clutch arms
|
|
GorseV8 |
07-11-2026 @ 7:39 PM
|
|
|
|
Member
Posts: 5
Joined: Dec 2012
|
Thankyou very much that is exactly the picture i recall seeing.
|
40 Coupe |
07-11-2026 @ 6:08 AM
|
|
|
|
Senior
Posts: 1839
Joined: Oct 2009
|
Your client is confused as to what part your talking about as was I. The 01A part number is for a 1940 part and 40 did not use an arm mounted on the clutch throw out shaft. The clutch arm for the 32 did come in a couple of variations. I believe one is reproduced try Third Gen Auto. in Tenn. The 4-Cyl arm is different.
This message was edited by 40 Coupe on 7-11-26 @ 6:30 AM
|
GorseV8 |
07-10-2026 @ 4:31 PM
|
|
|
|
Member
Posts: 5
Joined: Dec 2012
|
Sorry, I should have made myself clearer. The part I am referring to has the part number B? or 18-7511.
|
40 Coupe |
07-10-2026 @ 5:58 AM
|
|
|
|
Senior
Posts: 1839
Joined: Oct 2009
|
The Y shaped fingers that push the throw out bearing? The 32-35 fingers are slightly different because the throw out bearing had a grease cup. I do not remember a 01A (1940 part number) on any of the Y fingers. I believe they are 48- . If your going to use a sealed throw out bearing you do want the 48- fingers.
This message was edited by 40 Coupe on 7-10-26 @ 6:02 AM
|
GorseV8 |
07-09-2026 @ 3:29 AM
|
|
|
|
Member
Posts: 5
Joined: Dec 2012
|
I recall reading somewhere in the last 2 or 3 years reading about the differences in the early clutch lever arms for the 1932 and later gearbox? Does any one recall this also or may be able to help. I am putting together a 1932 gearbox and the client thinks the arm he has is correct but I tell him no, not with an 01A part number. Many thanks
|