Posted By |
Discussion Topic:
oil bath air cleaner
-- page:
1
2
|
|
supereal |
11-07-2019 @ 11:01 AM
|
|
|
Senior
Posts: 6819
Joined: Oct 2009
|
I certainly agree with my old friend Stroker. I remove the top of the oil bath air cleaner and replace the mesh with a modern dry element. The top is removed by carefully releasing the crimped edge. We use a metal plate to hold the element on place. A "duct blank plate" is ideal. They are available at most stores selling furnace parts. Just drill a hole in the center of the plate to permit the center "hold down" and crimp the top around the plate. I use a filter from NAPA. Put it in the body of the cleaner, then install the top with the wing nut. If you wish to further conceal the element, just spray a bit of paint through the mesh. We did a "how to" years ago, and will dig it up if anyone wants one. It is interesting to know that old Henry didn't think much of filters. He designed the carbs on early Fords, such as the Model A, with the intake facing toward the rear of the vehicle. His belief was that as the vehicle was moving forward, the dust would flow by the carb instead of into it. Given that most roads of the day were dirt or gravel. we can only guess that plenty of dirt and debris shortened engine life.
|
lightflyer1 |
12-16-2019 @ 1:47 PM
|
|
|
New Member
Posts: 107
Joined: Oct 2009
|
I use a small paper filer element when driving. I keep the original clean and in the car and when I stop and park for shows and such I put the original back on. All original when parked and the paper filter does a good job and is easy to swap out/change. The original looks pristine!
|
mhsprecher |
12-16-2019 @ 5:46 PM
|
|
|
Member
Posts: 51
Joined: Oct 2015
|
I would like to see the "how to."
|
c-gor |
12-18-2019 @ 7:18 AM
|
|
|
New Member
Posts: 129
Joined: Oct 2009
|
suggest you follow link to dry air cleaner http://www.norgv8club.org/all-dcouments-indexed/category/14-norg-tech-tips This worked for me
|
Bob-93021 |
12-18-2019 @ 1:24 PM
|
|
|
Member
Posts: 47
Joined: Jan 2011
|
c-gor, Thank you for posting the link to Northern Ohio Regional Group. It is a great website with a ton of technical information with pictures. I plan to do a re-wire of my 47 and found a very helpful article with pix of the wire routing.
|
supereal |
12-18-2019 @ 2:05 PM
|
|
|
Senior
Posts: 6819
Joined: Oct 2009
|
Leave your email address in my message inbox and I will send it to you.
|