Posted By |
Discussion Topic:
1946 Ford Convertible Dash Wiring Harness
|
|
mgeewhiz |
04-02-2020 @ 3:17 PM
|
|
|
Member
Posts: 11
Joined: Feb 2017
|
I have a mostly original 1946 Ford Convertible, but the under dash wiring is a jumble of wires that have been replaced over the years. I would like to start over with a complete re-wire to bring it back to its original state. Who are the best providers of an original type wiring harness. The car is still 6 volt, and is a solid driver. Any suggestions will be appreciated.
|
37RAGTOPMAN |
04-03-2020 @ 6:53 AM
|
|
|
Senior
Posts: 1940
Joined: Oct 2009
|
HI I used RHODE ISLAND wiring, comes with GREAT instructions and a phone number if you have any problems all correct colors, all soldered terminals, and correct terminals MADE IN USE, not FOREIGN made, just remember you get what you pay for, and MAKING what they SELL, !!!!!!!! 401 789 1955 riwire.com web site, hope this helps,1937Ragtopman
This message was edited by 37RAGTOPMAN on 4-15-20 @ 8:55 AM
|
TomO |
04-03-2020 @ 6:56 AM
|
|
|
Senior
Posts: 7243
Joined: Oct 2009
|
I like Rhode Island Wiring Service ( https://www.riwire.com/ ) and Tyree Harris wires ( 804-556-5200 ). There are more vendors that I have not tried, so I cannot give a comment on their quality.
Tom
|
kubes40 |
04-03-2020 @ 7:48 AM
|
|
|
Senior
Posts: 3368
Joined: Oct 2009
|
Rhode Island is perhaps the best there is. However, costly compared to folks like Carpenter. You say you have a nice "driver"? Might I suggest Carpenter for the wiring? Good quality that will hold up for years upon years... easy to follow schematics included and reasonably priced. I can't imagine having any questions in regard to installation... these old Fords are about as simple as can be. Mike "Kube" Kubarth
This message was edited by kubes40 on 4-3-20 @ 7:50 AM
|
mgeewhiz |
04-03-2020 @ 10:59 AM
|
|
|
Member
Posts: 11
Joined: Feb 2017
|
Thanks to all. The car is an older restoration that wasn't done quite right, so it give me lots of pleasure and small fun projects. I try my best to do it right when something needs doing. I appreciate your help and experience.
|
trjford8 |
04-04-2020 @ 10:23 AM
|
|
|
Senior
Posts: 4202
Joined: Oct 2009
|
I have had good luck with the wiring harnesses from Sacramento Vintage Ford.
|
supereal |
04-07-2020 @ 3:22 PM
|
|
|
Senior
Posts: 6819
Joined: Oct 2009
|
I agree on the sources. You will need a wiring diagram for your car. A convertible wiring is somewhat different than a closed car, so be sure that is addressed in your order. Looms are usually made to fit several models, so you may find some "extra" wires.
|