| Posted By |
Discussion Topic:
Tire pressure ?
|
|
OLDTMR |
05-27-2019 @ 4:33 PM
|
|
|
|
Member
Posts: 46
Joined: Dec 2010
|
Just a quick question, I have Auburn radials on my 40 car and do not remember what the pressure should. It sat all winter and just checked a tire which is at 30#. Pretty sure It is supposed to be a bit more ?
|
carcrazy |
05-27-2019 @ 4:48 PM
|
|
|
|
Senior
Posts: 1979
Joined: Oct 2009
|
I like to run 35 PSI in the radials on my 1953 Ford.
|
len47merc |
05-27-2019 @ 5:04 PM
|
|
|
|
Senior
Posts: 1168
Joined: Oct 2013
|
Given you are running radials there is no standard pressure - only personal preference for safe pressure for your tires. For total comfort 32, likely for even tread wear and optimum handling 35.
Steve
|
CharlieStephens |
05-27-2019 @ 6:21 PM
|
|
|
|
Senior
Posts: 922
Joined: Oct 2009
|
Did you look carefully at the sidewall to see if the recommended pressure is there?
|
OLDTMR |
05-28-2019 @ 8:27 AM
|
|
|
|
Member
Posts: 46
Joined: Dec 2010
|
I did look it over pretty well Charlie, but did not see pressure listed any place. I'll check it again for "kicks". 32 to 35 sounds pretty safe, thanks guys
|
supereal |
05-28-2019 @ 1:37 PM
|
|
|
|
Senior
Posts: 6819
Joined: Oct 2009
|
If you are using radial tires on rims designed for bias ply tires, be careful about overinflation because radials flex considerably more than bias type. I use 35 psi in my bias ply tires to minimize flat spotting after long periods sitting. On very old rims, it is often advised to put tubes in the radials for safety.
|
51f1 |
06-07-2019 @ 2:47 PM
|
|
|
|
Senior
Posts: 573
Joined: Oct 2009
|
The pressure on the tire sidewall is the maximum pressure. Most cars and trucks use somewhat less.
Richard
|