| Posted By |
Discussion Topic:
1950 ford transmission/ overdrive
|
|
40cpe |
04-22-2019 @ 3:22 PM
|
|
|
|
Member
Posts: 488
Joined: Jan 2010
|
As far as i know, 3.78 and 4.11 were the ratios offered in '50. I put an overdrive in a 3.78 ratio car and it performed/operated flawlessly. As said above, it won't make any difference.
|
carcrazy |
04-22-2019 @ 1:19 PM
|
|
|
|
Senior
Posts: 1981
Joined: Oct 2009
|
The ratio of the rear axle will have a minimal effect upon the operation of the overdrive. The overdrive operation is controlled by a governor located on the transmission. Approximate vehicle speed for the overdrive to engage is 27 MPH once the accelerator pedal is released. When the car is slowing down in overdrive as the speed drops below 21 MPH the car will return to direct drive. These speeds were determined with the as build final drive ratio. If the rear axle is changed and the ratio is not too far from the ratio for which the overdrive unit was calibrated, the O/D engagement and cut out points will only differ by a couple of MPH.
|
JT Ford |
04-22-2019 @ 11:29 AM
|
|
|
|
New Member
Posts: 112
Joined: Oct 2009
|
What difference does the rear end have to do with the operation???
|
supereal |
04-21-2019 @ 11:30 AM
|
|
|
|
Senior
Posts: 6819
Joined: Oct 2009
|
Determine the rear end gearing as it will determine the shift point of the OD, and will affect operation of the car.
|
fatso2114 |
04-17-2019 @ 8:52 AM
|
|
|
|
Member
Posts: 65
Joined: Oct 2016
|
Thanks JT ford for the info great help,John
|
JT Ford |
04-17-2019 @ 6:50 AM
|
|
|
|
New Member
Posts: 112
Joined: Oct 2009
|
No problem with the driveshaft. It will work with Std. tranny or OD.
|
fatso2114 |
04-16-2019 @ 4:32 PM
|
|
|
|
Member
Posts: 65
Joined: Oct 2016
|
Hello, want to put over drive in my 50 ford was wondering if I need a different drive shaft ( length) or can I use the same one in the over drive trans mission thanks for the help,John
|