| fortyoner | -- 06-04-2017 @ 4:14 PM |
|
I have a brace in for my 1941 Ford Coupe and I have no clue what or where it goes.I appreciate any help.
|
|
| ken ct. | -- 06-04-2017 @ 4:20 PM |
|
Could be part of hood latch assembly ??? Not sure. ken ct.
|
|
| fortyoner | -- 06-04-2017 @ 5:06 PM |
|
If it is I can't figure out how it ties in.Thanks for the input.
|
|
| TomO | -- 06-04-2017 @ 5:31 PM |
|
Give us the dimensions, it may help. Tom
|
|
| Drbrown | -- 06-04-2017 @ 6:53 PM |
|
Fender, running board ???
|
|
| fortyoner | -- 06-05-2017 @ 11:02 AM |
|
It isn't for the running boards.Here are the measurements,,,, 10 inches wide at the widest point,3 1/2 at the narrow end.the hole in the narrow end is 1 inch,around the hole is 3 flat head screws.at the top(?) are short wings(?) with a bolt hole in them. This message was edited by fortyoner on 6-5-17 @ 11:04 AM
|
|
| fortyoner | -- 06-05-2017 @ 11:05 AM |
|
pic didn't take
|
|
| cpipp01@aol.com | -- 06-05-2017 @ 5:36 PM |
|
1941 Ford grille cross bar brace part number 11A 8232 pictured on page 245 of the 1938 - 1941 Ford Mercury chassis book.
|
|
| ken ct. | -- 06-05-2017 @ 10:18 PM |
|
I was at the correct end of the car, LOL anyhow. ken ct.
|
|
| EFV-8 Club Forum : | https://www.earlyfordv8.org/forum |
| Topic: | https://www.earlyfordv8.org/forum/viewmessages.cfm?Forum=18&Topic=10827 |