RAK402 | -- 02-26-2021 @ 5:06 PM |
I never knew these existed, until I found them in "It's Ford for 40." My 40 Sedan has had washers holding the instrument panel in since I got it in 1975 (and I'm guessing long before that). Have the mounting plates been reproduced? Part # 01A-7004339 Thank you.
|
|
kubes40 | -- 02-27-2021 @ 5:21 AM |
No, they have not. However, they are easy to make with "basic" tools. Mike "Kube" Kubarth
|
|
RAK402 | -- 02-27-2021 @ 8:10 AM |
I will see if I can make them out of sheet metal. The photographs in your book will help immensely. Thank you Mike!
|
|
trjford8 | -- 02-27-2021 @ 9:19 AM |
I think sheet metal will bend when you tighten it down. I think you will need to use something heavier than sheet metal.
|
|
kubes40 | -- 02-27-2021 @ 2:52 PM |
Let me see if I can draw a sketch up for you. I should have a plate around here Give me a day... Mike "Kube" Kubarth
|
|
RAK402 | -- 02-28-2021 @ 12:40 AM |
Thank you sir!
|
|
kubes40 | -- 02-28-2021 @ 10:40 AM |
Here ya go: Mike "Kube" Kubarth
|
|
RAK402 | -- 02-28-2021 @ 4:42 PM |
Thank you very much, Mike!
|
|
EFV-8 Club Forum : | https://www.earlyfordv8.org/forum |
Topic: | https://www.earlyfordv8.org/forum/viewmessages.cfm?Forum=14&Topic=14640 |