| Ritzy1 | -- 12-24-2015 @ 5:14 AM |
|
When trying to get the pin (PN 352549-S) out of the clutch shaft on my '48 I broke it. Bob Drake lists it on their website, but it is out of stock. I've searched the other usual websites (Mac's, C&G, Carpenter, Joe's) without success. Does anyone know where I could buy one? Thanks, Dave
|
|
| cliftford | -- 12-24-2015 @ 7:36 AM |
|
A good machinist could make one.
|
|
| TomO | -- 12-24-2015 @ 8:33 AM |
|
Here is a link to one on E-bay http://www.ebay.com/itm/Ford-40-48-Transmission-clutch-equalizer-shaft-ball-bushing-spring-washer-pin-/261737985246 Tom
|
|
| woodiewagon46 | -- 12-24-2015 @ 12:51 PM |
|
I would think any good hardware store would have one very similar to the picture. Also, McMaster- Carr would have one listed under "clevis pins".
|
|
| woodiewagon46 | -- 12-24-2015 @ 12:55 PM |
|
I just checked McMaster-Carr and they have any size from 1/8" up to 1 and 1/4" in Stainless steel. Usually next day delivery.
|
|
| alanwoodieman | -- 12-24-2015 @ 1:26 PM |
|
got a tractor supply around you?--any good hardware store has them
|
|
| Ritzy1 | -- 12-24-2015 @ 1:32 PM |
|
Thanks!!
|
|
| 1935fordtn | -- 12-30-2015 @ 5:34 PM |
|
If you havent found one, Roy Nacewicz sells them
|
|
| Grant | -- 12-31-2015 @ 6:30 AM |
|
The Parts Department at your nearest John Deere dealership will likely have a pin like that in stock.
|
|
| EFV-8 Club Forum : | https://www.earlyfordv8.org/forum |
| Topic: | https://www.earlyfordv8.org/forum/viewmessages.cfm?Forum=18&Topic=9242 |