| fatso2114 | -- 09-22-2025 @ 4:28 AM |
|
Hello I was wondering how to peen the ends of the pin for the roller I don’t want to heat the pin and damage the needle bearings inside the roller the new pin only sticks out about a quarter of a inch on each side which is not a lot to work with any suggestions? Thanks John
|
|
| 40 Coupe | -- 09-22-2025 @ 4:45 AM |
|
Several spot welds.
|
|
| fatso2114 | -- 09-23-2025 @ 2:23 AM |
|
40 coupe thanks for the suggestion ,John
|
|
| EFV-8 Club Forum : | https://www.earlyfordv8.org/forum |
| Topic: | https://www.earlyfordv8.org/forum/viewmessages.cfm?Forum=18&Topic=17761 |