| Shane R. | -- 07-21-2025 @ 12:21 PM |
|
I have been searching for a good pair of front engine supports for my 36 Ford. Does anybody have a line on reproductions and or maybe have a good set to sell? Mine may be ok, but with the difficulty in replacing them I would rather do so now while the front end is apart rather than have my set begin to leak in a few years. Pictures of mine are below. Do you think I need to replace them? Thanks for any help you can offer. S This message was edited by Shane R. on 7-21-25 @ 2:52 PM
|
|
| nelsb01 | -- 07-21-2025 @ 3:57 PM |
|
They are not the worst that I have seen. And, if you are going to replace them, now would be the time. Replacements are available (used) in better shape. Suggest that you enter a Wanted Ad on this site. There are probably some available (again used) at large swap meets.
|
|
| Shane R. | -- 07-21-2025 @ 4:23 PM |
|
Thanks. I figured they weren't horrible. Used ones that I have seen look worse. I am still able to get a solid clamping surface. I guess with the system being unpressurized that is sufficient. That said, if somebody has a better set to sell I would be interested. S
|
|
| flatfoot | -- 07-28-2025 @ 4:15 PM |
|
Have you "Bob Drake" in Oregon or Dennis Carpenter?
|
|
| kubes40 | -- 07-28-2025 @ 5:16 PM |
|
Shane, I have a nice pair. Private message me. Mike "Kube" Kubarth
|
|
| Shane R. | -- 07-29-2025 @ 3:46 PM |
|
Flatfoot, I have tried both places and have not seen any in their parts listings. Thank you for the thoughts though. This message was edited by Shane R. on 7-29-25 @ 3:47 PM
|
|
| 51504bat | -- 07-29-2025 @ 5:58 PM |
|
If the ones from Kube don't work out try the Early Ford Store in San Dimas, CA https://www.earlyfordstore.com/ ______________ No signature
|
|
| EFV-8 Club Forum : | https://www.earlyfordv8.org/forum |
| Topic: | https://www.earlyfordv8.org/forum/viewmessages.cfm?Forum=18&Topic=17689 |