| kenburke | -- 11-13-2009 @ 5:59 PM |
|
In the restoration book on page 4-9, Figure 4-9, is that the correct hanger?
|
|
| kubes40 | -- 11-20-2009 @ 2:21 PM |
|
Hi Ken, Sorry I am tardy in reply. I overlooked your post... The hanger pictured in the current manual is NOT correct. The correct hanger has a rubber insulator. Carpenter sells one that is close to being correct. Part #99A-5261. As I recall the shaft is too long (compared to original). As long as we are on the subject, the front clamp & bracket #11A-5259 listed by Carpenter and others as correct for '40 is NOT in fact correct. The correct piece here appears very much like the rear tailpipe hanger. Mike Kubarth This message was edited by kubes40 on 1-30-10 @ 6:30 AM
|
|
| EFV-8 Club Forum : | https://www.earlyfordv8.org/forum |
| Topic: | https://www.earlyfordv8.org/forum/viewmessages.cfm?Forum=14&Topic=304 |