| yooper trooper | -- 08-19-2021 @ 8:47 AM |
|
How do I go about removing the speedo and gauges cluster?
|
|
| kubes40 | -- 08-19-2021 @ 9:21 AM |
|
From behind... four nuts. If memory serves, a 3/8" wrench is required. Note the four areas that are curved somewhat inward (two at the top, two at the bottom)... that's where the nuts are. Each nut holds a small metal plate that subsequently holds the gauge cluster in place. Mike "Kube" Kubarth This message was edited by kubes40 on 8-19-21 @ 9:24 AM
|
|
| trjford8 | -- 08-20-2021 @ 8:45 AM |
|
A good 1/4" drive nut driver with a 3/8" deep well socket will do the job. I found it easier than using a wrench. This message was edited by trjford8 on 8-20-21 @ 8:47 AM
|
|
| EFV-8 Club Forum : | https://www.earlyfordv8.org/forum |
| Topic: | https://www.earlyfordv8.org/forum/viewmessages.cfm?Forum=14&Topic=15086 |