| nsracarnut | -- 03-15-2012 @ 3:07 PM |
|
I need to know the proper placement for the channel on the glass in regards to the center pin that causes the glass to slide back. When I got the car it didn't have any glass in the doors so I don't have any reference to follow. If I center the new channel the pin will be about 12 1/2 from the rear of the glass.
|
|
| 40cpe | -- 03-16-2012 @ 1:40 PM |
|
I had one replaced a few months ago and had a glass shop re set the channel, so I didn't pay a lot of attention. If I remember right, the channel has a rounded or flat end the worked as a guide in the end felts and was about even with the end of the glass.
|
|
| EFV-8 Club Forum : | https://www.earlyfordv8.org/forum |
| Topic: | https://www.earlyfordv8.org/forum/viewmessages.cfm?Forum=18&Topic=4459 |