| Sparky marky | -- 04-04-2015 @ 5:48 PM |
|
Looking for factory drawing so I can put back to stock ? This message was edited by Sparky marky on 4-4-15 @ 5:50 PM
|
|
| TomO | -- 04-05-2015 @ 7:42 AM |
|
There are identification drawings in the Chassis Parts catalog. There are no dimensions on the drawings. Tom
|
|
| Sparky marky | -- 04-14-2015 @ 8:45 PM |
|
With the exception of the Glass lens are these the same as a 1936 passenger car light assembly ? The lights on my truck had been converted to sealed beam and the trim ring (that holds the glass had been cut to fit .
|
|
| nelsb01 | -- 04-14-2015 @ 9:08 PM |
|
I believe that 1938 commercial vehicle headlight buckets were deeper than 1936. For reference you can check out the grille drawings from the main page -- left column.
|
|
| Sparky marky | -- 04-15-2015 @ 6:31 PM |
|
The trim ring , gasket , lamp clips might be the same as a 36 ?
|
|
| TomO | -- 04-16-2015 @ 7:16 AM |
|
The Green book shows that the headlight door on trucks is the same for 1935-1939. Tom
|
|
| EFV-8 Club Forum : | https://www.earlyfordv8.org/forum |
| Topic: | https://www.earlyfordv8.org/forum/viewmessages.cfm?Forum=17&Topic=8383 |