donnicoli | -- 07-02-2015 @ 1:16 PM |
the front bumper brace grommets are wider on two sides. do the wider areas go to the outside and bottom?
|
|
kubes40 | -- 07-02-2015 @ 1:34 PM |
Yes - outside and bottom as you thought...
|
|
donnicoli | -- 07-02-2015 @ 2:21 PM |
Thanks Mike, now I can put the bumper on, just the hood left, I'm sure that will be fun! and I'll probably have ?'s. Don
|
|
TomO | -- 07-03-2015 @ 5:57 AM |
You may have to make some adjustments in the fenders and grill after the hood is installed and aligned to the cowl. I aligned the hood before I tightened the fenders and then made adjustments to the fenders to fit the hood. Tom This message was edited by TomO on 7-3-15 @ 6:00 AM
|
|
donnicoli | -- 07-03-2015 @ 3:56 PM |
Tom, thanks for the tips, it fit before, I have my fingers crossed! Don
|
|
std1940 | -- 08-16-2015 @ 3:31 PM |
Is that same on rear? Wide out & bottom? Thanks Tom.
|
|
Rustynutz52 | -- 09-20-2015 @ 6:34 AM |
Kube, Are these shown with the correct orientation in the photograph. It sounds like per your written description they are correctly oriented. If so I installed mine perfectly backwards last week. Thanks Mike
|
|
EFV-8 Club Forum : | https://www.earlyfordv8.org/forum |
Topic: | https://www.earlyfordv8.org/forum/viewmessages.cfm?Forum=14&Topic=8691 |