| shogun1940 | -- 10-26-2016 @ 4:58 PM |
|
Kubes would you have any pictures of floors from the under neath ? Ian trying to figure how close the floors should be to the rockers. I have paul bradley floors and Carpenter rockers.
|
|
| kubes40 | -- 10-27-2016 @ 8:10 AM |
|
I am not quite certain what you are seeking. Perhaps you can Pm me with more details???
|
|
| shogun1940 | -- 10-30-2016 @ 2:01 AM |
|
I am trying to get the floor pans aligned ,and I want to know if the original floors came all the way out to touch the the rockers. I have to weld in the hump section and I think that the opening is a little narrow . Do I cut the outside of the pan or the inside or a little of both. ? There is piece of steel at the bottom of the door post that goes under the cowl sticks out towards the rear and I am wondering if the rocker goes on the outside of it or the inside. I will gout and take some better pictures and post them. I am not in a rush, if the doc gives me the ok I will be heading south in a few weeks.
|
|
| shogun1940 | -- 11-01-2016 @ 9:06 AM |
|
Kubes I think the rocker goes under the steel cowl , but I wonder how far up it goes Iwil have to post another pic.
|
|
| shogun1940 | -- 11-01-2016 @ 9:07 AM |
|
Sec pic
|
|
| shogun1940 | -- 11-01-2016 @ 9:08 AM |
|
Third pic
|
|
| EFV-8 Club Forum : | https://www.earlyfordv8.org/forum |
| Topic: | https://www.earlyfordv8.org/forum/viewmessages.cfm?Forum=14&Topic=10204 |